Filter
Top Products
Connecting the
Grabbers to the
Probes
You connect the grabbers to the probes by slipping the connector at the
end of the probe onto the recessed pin in the side of the grabber. If you
need to use grabbers for either the pod or the probe grounds, connect them
to the ground leads the same way you connect them to the probes.
Connecting the
Grabbers to the
Test Points
The grabbers have a hook that fits around IC pins and component leads.
You connect the grabber by pushing the rear of the grabber to expose the
hook, hooking the lead and releasing your thumb as shown below.
Figure 2-9. Connecting Grabbers to Probes
Figure 2-10. Connecting Grabbers to Test Points
HP 16510B Probing
Front-panel Reference 2 - 11