Filter
Top Products
With this arrangement, the logic analyzer will clock the data when there is
a negative edge of the J clock OR a positive edge of the K clock, AND
when there is a high level on the M clock OR a low level on the N clock.
You must always specify at least one clock edge. If you try to use only
clock levels, the logic analyzer will display a message telling you that at
least one edge is required.
7 Pod Clock Your logic analyzer has the capability of clocking data in three different
ways. The pod Clock fields in the State Format Specification menu
allow you to specify which of the three ways you want to clock the data.
Each pod assigned to the state analyzer has a pod Clock field associated
with it. As with the Clock field discussed in the previous section, the pod
Clock fields are present only in the state analyzer. Selecting one of the
pod Clock fields gives you the following pop-up menu:
Figure 5-25. Pod Clock Field Pop-up Menu
HP 16510B Menus
Front-Panel Reference 5-23