Filter
Top Products
If you wish to stop a printout before it is completed, touch Cancel.This
stops the print and the message "Print Cancelled" appears at the top of the
display.
6Run The Run field allows you to start data acquisition. The pop-up that
appears when you touch this field contains the trace mode options Single,
Repetitive,andCancel. This field is explained in detail in "Run/Trace
Mode" in both the Timing and State Trace specification menus sections of
this chapter.
Subsystem
Level Menus
The HP 16510B logic analyzer is configured for measurements in the
Timing and State Format and Trace Specification menus. The Format
menus can be accessed by touching Format 1 or 2, and the Trace menus
by touching Trace 1 or 2.
The Format Specification menus let you specify how the logic analyzer
groups the input channels from your microprocessor. You can set the
threshold levels of the pods assigned to the analyzer, assign labels and
channels, specify symbols, and, in the case of the state analyzer, set clocks
for triggering.
The Trace Specification menus allow you to configure the logic analyzer
to capture only the data of interest in your measurement. The logic
analyzer acquires data until it triggers at a location that you specify by
setting certain parameters for the data. In the timing analyzer you can
configure the analyzer to trigger on specific patterns, edges, or glitches. In
the state analyzer you can configure the analyzer to trigger on a sequence
of states.
At power up, the logic analyzer is configured with a default setting. You
can use this default setting to make a test measurement on your system. It
can give you an idea of where to start your measurement.
Each of the format and trace specification menus will be covered in this
chapter. For examples on setting up configurations for measurements with
the timing and state analyzers, refer to your HP 16510B Getting Started
Guide or chapters 7 through 9 in this manual.
HP 16510B Menus
Front-Panel Reference 5-7