Filter
Top Products
Setting the
Timing Analyzer
Trigger
Your timing measurement requires the timing analyzer to display the
timing waveforms present on the buses when the routine is running. Since
you triggered the state analyzer on address 8930, you want to trigger the
timing analyzer so the timing waveforms can be time correlated with the
state listing.
To set up the logic analyzer so that the state analyzer triggers the timing
analyzer, perform these steps:
1. Display the Timing Trace Specification menu (Trace 2).
2. Touch the field labeled Armed by Run.
3. In the pop-up, touch the field labeled 68000STATE.
Your timing Trace specification should match the menu shown:
State Analyzer Arms
Timing Analyzer
Figure 12-8. Armed by 68000STATE
Using the Timing/State Analyzer HP 16510B
12-10 Front-Panel Reference