Filter
Top Products
Connecting the
Probe Cables
to the Logic
Analyzer
The probe cables are installed in the Logic Analyzer module at the factory.
The cable for pod 1 is the far left cable (rear view). Cables 2 through 5
follow cable 1 consecutively from left to right. If there is a need to install
or replace the cables refer the HP 16510B Service Manual.
Connecting the
Pods to the
Probe Cable
The pods of the HP 16510B differ from other logic analyzers in that they
are passive (have no active circuits at the outer end of the cable). The
pods, as they will be referred to for consistency, are the connector bodies
(as shown below) that the probes are installed in when you receive your
logic analyzer.
Toconnectapodtoacable,youalignthekeyonthecableconnectorwith
the slot on the pod connector and push them together.
Figure 2-7. Connecting Pods to Probe Cables
HP 16510B Probing
Front-panel Reference 2 - 9