Filter
Top Products
You can specify ranges that overlap or are nested within each other. They
must be specific. Don’t cares are not allowed.
The logic analyzer gives patterns priority over ranges when displaying
measurements. This will be covered in more detail in the sections "Timing
Waveforms Menus" and "State Listing Menus" later in this chapter. To
add more symbols to your symbol table, touch the field of the last symbol
defined. A pop-up menu appears as shown.
The first option in the pop-up is Add a Symbol.Itallowsyoutoadd
another symbol. When you select it, you will see an alphanumeric pop-up
menu. Use the keypad to enter the name of your new symbol. When you
select Done, your new symbol will appear in the Symbol Table.
The second option in the pop-up is Modify symbol. If you select this
option, you will see an alphanumeric pop-up menu with which you can
change the name of the symbol.
The third option in the pop-up is Delete Symbol. If you select this option,
the symbol will be deleted from the Symbol Table.
Leaving the Symbol Table Menu. When you have specified all your
symbols, you can leave the Symbol Table menu by touching Done.This
puts you back in the Format Specification menu that you were in before
entering the Symbol Table.
Figure 5-21. Symbol Pop-up Menu
Menus HP 16510B
5-20 Front-Panel Reference