Filter
Top Products
You select the trace mode by touching the Run field, and, without lifting
your finger from the screen, move it to the desired trace mode. When you
lift your finger, the logic analyzer traces data in the mode you specify. If
you wish to abort the trace after you touch Run but before the trace starts,
move your finger to Cancel before lifting your finger.
Single Trace mode acquires data once per trace. Repetitive Trace mode
repeats single acquisitions until Stop key is touched, or until conditions
specified with the X and O markers in the State Listing menu are met.
2ArmedBy The Armed By field is present when more than one analyzer is on at the
same time. The Armed by field lets you specify how your state analyzer is
to be armed. The analyzer can be armed by Run, the other analyzer, or an
external arm from the IMB (Intermodule Bus). "Intermodule
Measurements" are covered in chapter 10 of the HP 16500A Reference
Manual.
When you select the Armed by field, a pop-up menu appears like that
shown below. Use this menu to select the arming option for your analyzer.
With the menu, select the arming option for your analyzer.
Figure 5-65. Armed By Pop-up Menu
Menus HP 16510B
5-56 Front-Panel Reference