Filter
Top Products
Single Trace mode acquires data once per trace. Repetitive Trace mode
repeats single acquisitions until Stop is touched, or until the time interval
between two specified patterns is less than or greater than a specified
value, or within or not within a specified range. The Stop Measurement
feature is explained in detail in "Markers Pattern" in both the "Timing
Waveforms" and "State Listing" sections of Chapter 6 of this manual.
2ArmedBy The Armed By field is present when more than one analyzer is on at the
same time. The Armed by field lets you specify how your timing analyzer
is to be armed. The analyzer can be armed by Run, the other analyzer, or
an external arm from the IMB (Intermodule Bus). "Intermodule
Measurements" are covered in chapter 10 of the HP 16500A Reference
Manual.
When you select the Armed by field, a pop-up menu appears like that
shown below. Use this menu to select the arming option for your analyzer.
Figure 5-31. Armed By Pop-up Menu
HP 16510B Menus
Front-Panel Reference 5-29