Filter
Top Products
To assign bits to either Analyzer 1 or Analyzer 2 there must be at least one
pod assigned to the desired analyzer. If there are no pods assigned to the
analyzer you wish to use follow steps 1 and 2. If there is a pod assigned to
the desired analyzer go to step 3 where you access the Format menu.
1. Enter the State/Timing E Configuration menu.
2. Touch a Pod field. When the pop-up appears, assign the pod to the
analyzer of your choice.
3.Touchthefieldsecondfromleftinthetopleftcorner.Whenthe
pop-up appears, touch Format 1 (or 2).
4. Before you can select a bit pattern at least one label must be on. To
turn a label on, touch the label field and when the pop-up appears,
touch Turn Label On.
5. Touch the bit assignemnt field to access the bit assignment pop-up.
6. When the pop-up appears, using the KNOB, place the cursor on the
desired bit and touch the asterisk to assign a bit or the period to
unassign a bit. Touch Done when bit assignment is complete.
When the pop-up closes the bit assignment field is again displayed,
however, now it is displayed with the assigned pattern.
Using the Front-Panel Interface HP 16510B
3-12 Front-Panel Reference