Filter
Top Products
Probe Cable
Installation
The HP 16510B State/Timing Module comes with probe cables installed
by the factory. If a cable is to be switched or replaced, refer to "Probe
Cable Replacement" in Section VI of the HP 16510B Service Manual.
Installation
Caution Do not install, remove or replace the module in the instrument unless the
instrument power is turned off.
The HP 16510B State/Timing Module will take up one slot in the card
cage. For every additional HP 16510B State/Timing Module you install,
you will need an additional slot. They may be installed in any slot and in
any order. Procedures for installing the logic analyzer module cards are
shown in the step-by-step procedure in the following paragraphs.
Module
Installation
The following procedure is for the installation of the HP 16510B Logic
Analyzer Module.
Caution The effects of ELECTROSTATIC DISCHARGE can damage electronic
components. Use grounded wrist straps and mats when you are performing
any kind of service to this module.
Installation
Considerations
• The HP 16510B State/Timing Module(s) can be installed in any
available card slot and in any order.
• Cards or filler panels below the empty slots intended for module
installation do not have to be removed.
• The probe cables do not have to be removed to install the module.
Installing New Logic Analyzer Boards into the Mainframe HP 16510B
A-2 Front-Panel Reference