Filter
Top Products
12
Using the Timing/State Analyzer
Introduction In this chapter you will learn how to use the timing and state analyzers
interactively by setting up the logic analyzer to make a simple
measurement. We give you the measurement results as actually measured
by the logic analyzer, since you may not have the same circuit available.
The exercise in this chapter is organized differently than the two previous
chapters. Since you have already set up both the timing and state
analyzers, you should be ready to set them up for this measurement by
looking at the menu pictures.
Any new set-ups in this exercise will be explained in task format steps like
the previous chapters.
How you use the steps depends on how much you remember from
previous chapters. If you can set up each menu by just looking at the menu
picture, go right ahead and do so. If you need a reminder of what steps to
perform, follow the numbered steps. If you still need more information
about "how," use the lettered steps.
HP 16510B Using the Timing/State Analyzer
Front-Panel Reference 12-1