Filter
Top Products
Specifying
Patterns
The Pattern field appears in several menus. Patterns can be specified in
one of the available number bases. Patterns can be viewed in ASCII, but
cannot be entered in ASCII.
The convention for "don’t care" in these menus is an X except in the
decimal base. If the base is set to decimal after a "don’t care" is specified,
a $ will be displayed.
To select a pattern, enter the Trace menu and follow these steps:
1. Touch the field to the right of Pattern. You will see a keypad pop-up
(see figure 3-10).
2. Using the alphanumeric keyboard, enter the desired pattern.
Note The Base > field and the Find Pattern field are interactive. Only a keypad
that is compatible with the selected base will appear when the pop-up
opens. Since ASCII patterns cannot be entered directly, a keypad will not
appear for data entry if the base is set to ASCII.
When the pop-up is open, you enter your desired pattern from the keypad
(including don’t cares). When you finish entering your pattern, close the
pop-up by touching Done.
Figure 3 - 10. Specifying Patterns Keypad Pop-up
Menu
HP 16510B Using the Front-Panel Interface
Front-Panel Reference 3-13