Filter
Top Products
3. Assign the channels connected to the input signals (Pod 1 bits 0 and
1) to the labels RAS and CAS respectively.
a. Touch the bit assignment field below Pod 1 and to the right of
RAS.
b. Any combination of bits may be assigned to this pod; however,
you will want only bit 0 assigned to the RAS label. The easiest
way to assign bits is to touch CLEAR to un-assign any assigned
bits before you start.
c. Use the knob to position the cursor on bit 0 (right most bit) in the
bit assignment pop-up and touch the asterisk field. This will
placeanasteriskinthe0bit.TouchDONE when the asterisk is
in place.
d. Assign Pod 1 bit 1 to the CAS label by touching the CAS bit
assignment field and placing the cursor on bit one and touching
the asterisk. Touch DONE when complete.
Using the Timing Analyzer HP 16510B
7 - 6 Front-Panel Reference