APPENDIX
Appendix 4 Parameter List
295
A
■High Speed Counter
■Pulse Width Measurement
Classification-Level 1 Classification-Level 2 Classification-Level 3
Basic Settings Use/Do Not Use Counter Use/Not Use
Operation Mode Operation Mode
Pulse Input Mode Pulse Input Mode
Preset Input Preset Input Enable/Disable
Input Logic
Preset Value
Input Comparison Enable/Disable
Control Switch
Enable Input Enable Input Enable/Disable
Input logic
Ring Length Setting Ring Length Enable/Disable
Ring Length
Measurement Unit Time Measurement Unit Time
Pulse No. of per Rotation Pulse No. of per Rotation
High Speed Compare Table Counter CH
Comparison Type
Output Destination Device
Comparison Value 1 Specification Method
Comparison Value 1 Direct
Comparison Value 1 Indirect
Comparison Value 2 Specification Method
Comparison Value 2 Direct
Comparison Value 2 Indirect
Multi-point Output High Speed Compare
Table
Enable/Disable
Device
Comparison Value
Output Device
Output Data (HEX)
Table Data/Counter CH/Output Data/Points
Occupied input (X) Explanation 1-Phase 1 Count (S/W Updown Switch) CH1 to 8
1-Phase 1 Count (H/W Updown Switch) CH1 to 8
1-Phase 2 Input CH1 to 8
2 Phase Counts CH1 to 8
Other Specification method for high speed counter Specification method for high speed counter
Classification-Level 1 Classification-Level 2 Classification-Level 3
Basic Settings Use Pulse Width Measurement Use/Not Use
Input Signal Input Signal
Logical Switch Logical Switch
Measurement Mode Measurement Mode