Filter
Top Products
Configuring an M2PA System 129
Smart Media Software Configuration Guide 5 • Configuring SIGTRAN Applications
Creating SS7 Point Codes
Point codes are used to define the Smart Media system network, the adjacent network and the target network
so
that calls are properly routed from one network to the next.
To create SS7 originating (OPC) and destination (DPC) point codes:
1. Se
lect Point Codes from the navigation panel:
Figure 185. SS7 > Point Codes
2. Click Create New Point Code:
Figure 186. Point Codes
3. Configure the new point code:
–Enter a na
me for the point code
– Select a point code ty
pe (select type-specific parameters)
– Select a point code le
ngth (14, 16, 24 bits)
–Enter a po
int code
–Click Cre
ate
Figure 187. Creating the New MTP3 Point Code