Filter
Top Products
Configuring an M3UA System on IP Signaling Points 166
Smart Media Software Configuration Guide 5 • Configuring SIGTRAN Applications
Configuring an M3UA System on IP Signaling Points
In this configuration, the SS7 MTP2 and MTP3 layers are replaced entirely by the SIGTRAN M3UA layer.
This application is typically used between two IP Signaling Points. Refer to the following sections to configure
an M3UA system:
1. “Adding an Adapter” on
page 117
2. “Creating the SCTP Configuration” on pag
e 124
3. “Creating SS7 Point Codes” on p
age 129
4. “Creating an M3UA Configuration (IPSP)” on
page 167
– “Creating an M3UA SAP” on
page 168
– “Creating an M3UA Network” on p
age 169
– “Creating an M3UA User Part” on
page 170
– “Creating an M3UA Peer Signaling Process (IPSP)” on
page 171
– “Creating an M3UA Peer Server” on p
age 173
– “Creating an M3UA Route” on
page 175
5. “Creating an ISUP Stack” on
page 138
– “Creating an ISUP Network” on
page 139
– “Creating an ISUP User Part” on
page 141
– “Creating an ISUP Interface” on
page 142
– “Creating ISUP CIC Groups” on
page 144
– “Creating a NAP (SIGTRAN)” on
page 145