Filter
Top Products
Configuring an M3UA System on IP Signaling Points 167
Smart Media Software Configuration Guide 5 • Configuring SIGTRAN Applications
Creating an M3UA Configuration (IPSP)
To set up your M3UA system on an IP server process (IPSP), you must first create a new M3UA configuration.
In thi
s configuration the SS7 MTP2 and MTP3 layers are replaced entirely by the SIGTRAN M3UA layer.
This system is typically set up on two IP signaling points. To create an M3UA configuration on IPSP:
1. Se
lect M3UA from the navigation panel:
Figure 270. SS7 > M3UA
2. Configure the M3UA service for IPSP:
–Enter a na
me for the configuration
– Select IP S
erver Process (IPSP) as the node type
–Click Cre
ate
Figure 271. Creating the New M3UA Configuration
3. Verify that the "M3uaCfg was successfully created" message displays.
Figure 272. Successful Configuration Message
Understanding Parameters for M3UA Configurations
Table 61. Configuration Parameters for New M3UA Configurations
Parameter Description
Name Used by the Web Portal to indicate a specific object or string in the system
Node Type Assigns a configuration to an M3UA network. Possible values:
Signaling Gateway Process (SGP)
Application Server Process (ASP)
IP Server Process (IPSP)