Filter
Top Products
Configuring an M2PA System 131
Smart Media Software Configuration Guide 5 • Configuring SIGTRAN Applications
Creating an MTP3 Configuration
MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1. Se
lect MTP3 from the navigation panel:
Figure 189. SS7 > MTP3
2. Configure the new MTP3 service:
–Enter a na
me for the MTP3 configuration
– Make sure the En
abled and SSf Validation boxes are checked
– Select SP as
the signaling point type
– Select a re
start procedure
–Click Cre
ate
Figure 190. Creating the New MTP3 Configuration
3. Verify that the "Mtp3Cfg was successfully created" message appears, and that the Enabled box is
checked.
Figure 191. Successful Configuration Message