Filter
Top Products
Configuring an M3UA System on IP Signaling Points 170
Smart Media Software Configuration Guide 5 • Configuring SIGTRAN Applications
Understanding Parameters for M3UA Networks
Creating an M3UA User Part
After you have created an M3UA network, you must create a new M
3UA user part. To create an M3UA user
part:
1. Cl
ick Create New M3ua Userpart in the M3UA network configuration window:
Figure 280. M3UA Network Configuration Window: Create M3UA User Part
2. Configure the new M3UA user part:
–Enter a na
me for the user part
– IMPORTAN
T:
–For a system set up on a S
ignaling Gateway: Select an MTP3 network
–For a system set up on IP
SP or ASP, the MTP3 network field is not visible.
–Click Cre
ate
Figure 281. Creating the New M3UA User Part
Table 63. Configuration Parameters for New M3UA Networks
Parameter Description
Name Used by the Web Portal to indicate a specific object or string in the system
Protocol Type Identifies the SS7 protocol variant that will be used with a particular object. The
appropriate protocol variant depends on the user's geographical location.
Values are chosen from a drop-down list. The Protocol Type parameter can take
on the following values, depending on the object being configured:
ITU
ITU88
ITU92
ITU97
TELCORDIA
ANSI88
ANSI92
ANSI95
SINGAPORE
Q767
TTC
NTT
CHINA
ETSI
ETSIV3
UK
Sub Service Field Differentiates between national and international signals in MTP3 networks.
Possible values: International/National/Nat. Reserved/Inter. Reserved
DPC Length Sets a format for the destination point code (DPC) used by an object.
Possible values:
14bits format=3.8.3 / 16bits format=7.4.5 / 24bits format=8.8.8
SLS Range Used to route MPT3 links in the SS7 network