Filter
Top Products
Working with Configurations 30
Smart Media Software Configuration Guide 1 • Getting Started with the Web Portal
Working with Configurations
This section explains how to manage applications and instances on the SmartNode Web Portal, how to activate
a configuration, and how to configure IP interfaces. Refer to the following sections for information on:
• “Managing Applications” on
page 30
• “Activating the Configuration” on p
age 33
Managing Applications
This section explains how to start up
and verify applications and instances on the Smart Media application
server.
Viewing the List of Installed Applications
The Smart Media application server is designed to run a l
arge variety of applications. Before you can run an
application, you must first be able to view it from a list of applications. To view the selection of applications:
1. Se
lect Instances from the navigation panel.
Figure 16. Applications > Instances
2. The Application Instance List is displayed in the information panel.
Figure 17. Application Instance List
Applications are displayed in one of three states:
– Run (application is operating)
– Management (application is installed but not in operation)
– Fault (application has an operation fault)
Starting an Application
In order to be able to load and start an ap
plication, it will need to have been installed on the Smart Media
application server. In addition, at least one Smart Media unit must have been configured on the Smart Media
application server so that you are able to connect to it.