Filter
Top Products
Configuring an M3UA System on an Application Server 189
Smart Media Software Configuration Guide 5 • Configuring SIGTRAN Applications
Creating an M3UA ISUP Network
After you have created an initial ISUP stack, you must create a new ISUP network. The ISUP network tells the
ISU
P protocol layer about a collection of SS7 nodes that are accessible through MTP3 or M3UA. Based upon
your system configuration, one or more ISUP networks are created. Repeat this section for as many networks
as you require.
Note
An ISUP network can be used by multiple ISUP interfaces even if
they are members of different ISUP userpart (e.g., to support multi-
ple switch variants for a single SS7 network).
To create an M3UA ISUP network:
1. Cl
ick "Create New ISUP Network" in the ISUP stack configuration window:
Figure 317. Editing ISUP Networks
2. Configure the new ISUP network:
–Enter a na
me for the network
– Select M3
UA as the type of network to bind
– Select an M3
UA Userpart
–Click Cre
ate
Figure 318. Creating the New M3UA ISUP Network
3. Verify that the "IsupNetwork was successfully created" message displays.
Figure 319. Successful ISUP Network Message