Filter
Top Products
Configuring the ISUP Layer 96
Smart Media Software Configuration Guide 4 • Configuring SS7 Signaling
3. Configure the new MTP3 service:
– Make sure the box labeled En
abled is checked
–Enter a na
me for the stack
– Select a p
rimary hardware adapter
– Select a se
condary hardware adapter
–Click Cre
ate
Figure 133. Creating the New ISUP Stack
4. Verify that the "IsupStack was successfully created" message displays.
Figure 134. Successful ISUP Stack Message
Understanding Parameters for ISUP Stacks
Table 23. Configuration Parameters for New ISUP Stack
Parameter Description
Name Used by the Web Portal to indicate a specific object or string in the sys-
tem
Primary Hardware Adapter Identifies a main Smart Media hardware device to run an ISUP stack
Secondary Hardware Adapter Identifies a secondary (backup) Smart Media hardware device to run
an ISUP stack