Filter
Top Products
Working with Configurations 32
Smart Media Software Configuration Guide 1 • Getting Started with the Web Portal
Verifying that an Application is Operating
When an application’s target state is set to run, there ar
e a number of crucial verifications that you should con-
duct in order to know that an application is running properly. These verifications are as follows:
• Veri
fy the application’s current path. It is important that once the application has been set to run, a path
is displayed.
• Veri
fy the TDM interface. If you are running a TDM application on your Smart Media unit then you can
verify the TDM interface. Although, you most likely have not yet configured the TDM interface of the
Smart Media unit, certain status LEDS will indicate that your application is operational.
• Ve
rify the IP Interfaces. Your Smart Media unit is furnished with two IP interfaces for access to a VoIP
network. Although you have not as of yet configured the interfaces, certain LED indications will be dis-
played. See Figure 21 below.
Figure 21. SmartNode Interfaces
Verifying the Application Path
One important indication of the normal operation of an application is when the application path is displayed
i
n the hardware status window. To verify that the application path is displayed:
1. Se
lect Instances from the navigation panel.
2. Cl
ick the Status tab, in the Application Instances window, to view the application path
3. V
erify that the application path is displayed. Verify that the target state is set to Run, the current state dis-
plays Rea
dy, and the current HA state displays Active.
Figure 22. Application Status List