Filter
Top Products
Configuring an M2PA System 139
Smart Media Software Configuration Guide 5 • Configuring SIGTRAN Applications
–Click Create
Figure 207. Creating the New ISUP Stack
4. Verify that the "IsupStack was successfully created" message displays.
Figure 208. Successful ISUP Stack Message
Understanding Parameters for ISUP Stacks
Creating an ISUP Network
After you have created an initial ISUP stack, you must create a new ISUP network. The ISUP network tells the
ISU
P protocol layer about a collection of SS7 nodes that are accessible through MTP3 or M3UA. Based upon
your system configuration, one or more ISUP networks are created. Repeat this section for as many networks
as you require.
Note
An ISUP network can be used by multiple ISUP interfaces even if
they are members of different ISUP userpart (e.g., to support multi-
ple switch variants for a single SS7 network).
To create an ISUP network:
1. Cl
ick "Create New ISUP Network" in the ISUP stack configuration window:
Figure 209. Editing ISUP Networks
Table 42. Configuration Parameters for New ISUP Stack
Parameter Description
Name Used by the Web Portal to indicate a specific object or string in the sys-
tem
Primary Hardware Adapter Identifies a main Smart Media hardware device to run an ISUP stack
Secondary Hardware Adapter Identifies a secondary (backup) Smart Media hardware device to run
an ISUP stack