Filter
Top Products
Calibration Procedures Teledyne API – T101 Operation Manual
180
Table 6-3. AutoCal Attribute Setup Parameters
Attribute Name ACTION
Timer Enabled Turns on the Sequence timer
Starting Date Sequence will operate on Starting Date
Starting Time Sequence will operate at Starting Time
Delta Days Number of days to skip between each sequence
Delta Time Incremental delay on each Delta Day that the sequence starts.
Duration Duration of the sequence in minutes
Calibrate Enable to do dynamic zero/span calibration, disable to do a cal check only.
This must be set to OFF for units used in US EPA applications and with IZS
option installed.
NOTE
The programmed STARTING_TIME must be a minimum of 5 minutes later than the real
time clock (See Section 4.4.6 for setting real time clock).
NOTE
Avoid setting two or more sequences at the same time of the day. Any new sequence
which is initiated whether from a timer, the COM ports, or the contact closure inputs will
override any sequence which is in progress.
NOTE
If at any time an illegal entry is selected (Example: Delta Days > 367) the ENTR button
will disappear from the display.
07266B DCN6485