Filter
Top Products
Introduction Teledyne API – T101 Operation Manual
20
1.2. OPTIONS
The options available for your analyzer are presented in Table 1-1 with name, option
number, a description and/or comments, and if applicable, cross-references to technical
details in this manual, such as setup and calibration. To order these options or to learn
more about them, please contact the Sales department of Teledyne - Advanced Pollution
Instruments at:
TOLL-FREE: 800-324-5190
TEL: +1 858-657-9800
FAX: +1 858-657-9816
E-MAIL: apisales@teledyne.com
WEB SITE: http://www.teledyne-api.com/
Table 1-1. Analyzer Options
Option
Option
Number
Description/Notes
Pumps
Pumps meet all typical AC power supply standards while exhibiting
same pneumatic performance.
10A External Pump 100V - 120V @ 60 Hz
10B External Pump 220V - 240V @ 50 Hz
10C External Pump 220V - 240V @ 60 Hz
10D External Pump 100V – 12V @ 50 Hz
10E External Pump 100V @ 60 Hz
11A Pumpless (if one is standard either internal or external)
13 High Voltage Internal Pump 240V @ 50Hz
Rack Mount
Kits
Options for mounting the analyzer in standard 19” racks
20A Rack mount brackets with 26 in. chassis slides
20B Rack mount brackets with 24 in. chassis slides
21 Rack mount brackets only (compatible with carrying strap, Option 29)
23 Rack mount for external pump pack (no slides)
Carrying Strap/Handle Side-mounted strap for hand-carrying analyzer
29
Extends from “flat” position to accommodate hand for carrying.
Recesses to 9mm (3/8”) dimension for storage.
Can be used with rack mount brackets, Option 21.
Cannot be used with rack mount slides.
CAUTION
GENERAL SAFETY HAZARD
A FULLY LOADED T101 WITH VALVE OPTIONS WEIGHS >20 KG (45
POUNDS).
To avoid personal injury we recommend that two persons lift and carry the
analyzer. Disconnect all cables and tubing from the analyzer before moving it.
07266B DCN6485