Filter
Top Products
Teledyne API – T101 Operation Manual Operating Instructions
79
To access and navigate the VARS menu, use the following touchscreen button sequence:
See Section 6.8.1
for instructions
regarding this setting
SETUP X.X 0 ) MEASURE_MODE=H2S
NEXT JUMP EDIT PRNT EXIT
SETUP X.X 1 ) DAS_HOLD_OFF=15.0 Minutes
NEXT JUMP EDIT PRNT EXIT
SETUP X.X 1 ) TPC_ENABLE=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X DAS_HOLD_OFF=15.
0
Minutes
1 5 .0 ENTR EXIT
SETUP X.X 3)RCELL_SET=50.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.
X
3) IZS_SET=50.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
DO NOT change
theses set-points
unless
specifically
instructed to by
T-API Customer
Service.
SETUP X.X CLOCK_ADJ=0 Sec/Day
+ 0 0 ENTR EXIT
SETUP X.
X
8) CLOCK_
A
DJ=0 Sec/Da
y
PREV NEXT JUMP EDIT PRNT EXIT
EXIT ignores the new setting.
ENTR accepts the new setting.
SETUP X.X TPC_ENABLE=ON
ON ENTR EXIT
SETUP X.X 5 ) DYN_ZERO=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.
X
DYN_ZERO=ON
ON ENTR EXIT
Toggle to change setting
Toggle to change setting
SETUP X.X 6) DYN_SPAN=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.
X
DYN_SPAN=ON
ON ENTR EXIT
Toggle to change setting
Toggle to change setting
Toggle each to change setting
SETUP X.X CONC_PRECISION : 3
AUTO 0 1 2 3 4 ENTR EXIT
SETUP X.X 7) CONC_PRECISION : 1
PREV NEXT JUMP EDIT PRNT EXIT
Toggle each to change settings
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SAMPLE RANGE = 500.0 PPB H2S =XXX.X
< TST TST > CAL SETUP
07266B DCN6485