Filter
Top Products
4/00 UDC 3300 Process Controller Product Manual 141
Lower Display
Prompt
Upper Display
Range of Setting
or Selection
Parameter
Definition
A1S2TYPE
Same as A1S1 TYPE ALARM 1 SETPOINT 2 TYPE—Select what you want
Setpoint 2 of Alarm 1 to represent.
The selections are the same as A1S1TYPE.
A2S1TYPE
Same as A1S1 TYPE ALARM 2 SETPOINT 1 TYPE—Select what you want
Setpoint 1 of Alarm 2 to represent.
The selections are the same as A1S1TYPE.
ATTENTION
Not applicable with Relay Duplex or
Position Proportional outputs.
A2S2TYPE
Same as A1S1 TYPE ALARM 2 SETPOINT 2 TYPE—Select what you want
Setpoint 2 of Alarm 2 to represent.
The selections are the same as A1S1TYPE.
ATTENTION
Not applicable with Relay Duplex or Position
Proportional outputs.
A1S1 H L
A1S1 EV
HIGH
LOW
BEGIN
END
If Setpoint Programming is disabled or if the Alarm
Type is not configured for Event On/Off:
ALARM 1 SETPOINT 1 STATE—Select whether you want
the alarm type chosen in prompt A1S1TYPE to alarm High
or Low.
HIGH ALARM
LOW ALARM
If Setpoint Programming is enabled and if the Alarm
Type is configured for Event On/Off:
ALARM 1 SEGMENT EVENT 1—Select whether you want
the alarm type chosen in prompt A1S1TYPE to alarm the
beginning or end of a segment in setpoint Ramp/Soak
programming.
BEGINNING OF SEGMENT
END OF SEGMENT
ATTENTION
Alarms configured for events will not
operate on Setpoint Program segments of zero length.
A1S2 H L
A1S2 EV
HIGH
LOW
BEGIN
END
ALARM 1 SETPOINT 2 STATE—Same as A1S1 H L.
ALARM 1 SEGMENT EVENT 2—Same as A1S1 EV.
A2S1 H L
A2S1 EV
HIGH
LOW
BEGIN
END
ALARM 2 SETPOINT 1 STATE—Same as A1S1 H L.
ALARM 2 SEGMENT EVENT 1—Same as A1S1 EV.
A2S2 H L
A2S2 EV
HIGH
LOW
BEGIN
END
ALARM 2 SETPOINT 2 STATE—Same as A1S1 H L.
ALARM 2 SEGMENT EVENT 2—Same as A1S1 EV.