Filter
Top Products
66 UDC 3300 Process Controller Product Manual 4/00
3.19 Alarms Set Up Group
Introduction
This data deals with the Alarms function that is available with your
controller.
There are two alarms available. Each alarm has two setpoints. You can
configure each of these two setpoints to alarm on one of several events
and you can configure each setpoint to alarm high or low. You can also
configure the two setpoints to alarm on the same event and to alarm both
high and low, if desired.
Function prompts
Table 3-16 lists all the function prompts in the Alarms Set Up group.
Table 3-16 Alarms Group Function Prompts
Function Prompt
Lower Display
Function
Name
Selections or
Range of Setting
Upper Display
Factory
Setting
Refer
to
A1S1 VAL
Alarm 1 Setpoint 1 Value Value in engineering units 90
A1S2 VAL
Alarm 1 Setpoint 2 Value Value in engineering units 10
Section
4.15
A2S1 VAL
Alarm 2 Setpoint 1 Value Value in engineering units 95
A2S2 VAL
Alarm 2 Setpoint 2 Value Value in engineering units 5