![](http://pdfasset.owneriq.net/9/1c/91c200c6-83ea-41d6-9a2d-4cbdebe83b07/91c200c6-83ea-41d6-9a2d-4cbdebe83b07-bgdc.png)
208 UDC 3300 Controller Product Manual 4/00
Ramp unit
This determines the engineering units for the ramp segments.
The selections are:
TIME = Hours.Minutes
RATE = EU/MIN or EU/HR
ATTENTION
This selection cannot be changed while a program is in
operation.
ATTENTION
The Accutune TUNE selection will operate during setpoint programming.
When it is initiated during a program, it places the program into Hold
until it completes, then returns it to either Run or Hold depending what
the state was before Tuning started.