Filter
Top Products
4/00 UDC 3300 Process Controller Product Manual 79
Section 4 – Configuration Prompt Definitions
4.1 Overview
Introduction
This section provides information for all the user configurable parameters
listed in Section 3 - Configuration. If you are not familiar with these
parameters, this section gives you the parameter prompt, the selection or
range of setting that you can make, and a definition of how each parameter
setting affects controller performance. It will also refer you to any other
prompts that might be affected by your selection.
What’s in this
section?
The table below lists the topics that are covered in this section. They are
listed in the order of their appearance in the controller.
Topic See Page
4.1 Overview 79
4.2 Loop 1 Tuning Parameters Set Up Group 80
4.3 Loop 2 Tuning Parameters Set Up Group 84
4.4 Setpoint Ramp/Rate/Programming Set Up Group 85
4.5 Accutune Set Up Group 88
4.6 Algorithm Data Set Up Group 92
4.7 Output Algorithm Set Up Group 109
4.8 Input 1 Set Up Group 112
4.9 Input 2 Set Up Group 116
4.10 Input 3 Set Up Group 117
4.11 Loop 1 Control Set Up Group 118
4.12 Loop 2 Control Set Up Group 124
4.13 Options Set Up Group 129
4.14 Communications Set Up Group 135
4.15 Alarms Set Up Group 139
4.16 Display Parameters Set Up Group 143
4.17 Calibration Data 144
4.18 Maintenance Set Up Group 144
4.19 Status Test Data 146