Filter
Top Products
146 UDC 3300 Process Controller Product Manual 4/00
Lower Display
Prompt
Upper Display
Range of Setting
or Selection
Parameter
Definition
(continued)
TUNE2
Failsafe mode.
LOOP 2 TUNE—Number of times Loop 2 has been tuned
(manually and automatically).
COUNTS1
0-9999 (1 = 1000 counts for
output relays 1 and 2)
Shows the value of Counter 1. Read only.
COUNTER2
Same as COUNTER1 Counter 2 counts the number of times the selected event
has occurred.
COUNTS2
Same as COUNTS1 Shows the value of Counter 2. Read only.
COUNTER3
Same as COUNTER1 Counter 3 counts the number of times the selected event
has occurred.
COUNTS3
Same as COUNTS1 Shows the value of Counter 3. Read only.
PASSWORD
0-9999 PASSWORD—Entering the designated number resets to
zero the timer or counter specified by Reset Type.
To designate a number as the password:
1. Set all timers and counters to DISABL.
2. Enter the desired PASSWORD (0-9999).
3. Select a Reset Type (next prompt). The PASSWORD
goes into effect when you press FUNC
, that is, you can
use it to reset the counters and timers.
RES TYPE
NONE
TIMER1
TIMER2
TIMER3
ALL TM
COUNT1
COUNT2
COUNT3
ALL CO
ALL TC
RESET TYPE—Select which timers and/or counters will
be reset to zero when the PASSWORD is entered.
NONE—No values will be reset
TIMER 1 will be reset
TIMER 2 will be reset
TIMER 3 will be reset
ALL TIMERS will be reset
COUNTER 1 will be reset
COUNTER 2 will be reset
COUNTER 3 will be reset
ALL COUNTERS will be reset
ALL TIMERS AND COUNTERS will be reset
4.19 Status Test Data
Introduction
The prompts used here are for determining the reason for a controller
failure. Refer to the Section 8 – Troubleshooting in this manual for
complete information.