Filter
Top Products
7-2 Keypad Operation MN792
Keypad LED Status
Seven LEDs indicate the status of the Control. Each LED (Figure 7-1) can operate in three different ways:
Off
,
Blink
, and
On
.
Table 7-1 Control Status
OK Run Stop Control Status
Re–Configuration
Tripped
Stopped
Stopping
Running with Zero Reference
Running
Autotuning
Table 7-2 Forward Reverse Status
FWD REV Forward/Reverse Status
Commanded direction and actual direction are Forward.
Commanded direction and actual direction are Reverse (Series 30 only).
Commanded direction is Forward but actual direction is Reverse (Series 30 only).
Commanded direction is Reverse but actual direction is Forward.
Table 7-3 Local and Remote Status
SEQ REF Local/Remote Status
Start/Stop (Seq) and Speed Control (Ref) are controlled from the terminals (Remote).
Start/Stop (Seq) and Speed Control (Ref) are controlled from the keypad (Local).
Alarm Messages Operational failures called “Faults” or “Trips” are displayed at the keypad when they occur. They are also stored
in memory and can be accessed for viewing. When a fault occurs, the control will “Trip” which means the motor
stops and the control is disabled until it is reset. Press the “E” key to acknowledge the trip condition without
resetting the fault. After the fault condition has been cleared press the Reset button to reset the control to
restore operation. Refer to the Troubleshooting Section of this manual for additional information.