Filter
Top Products
Appendix A
CE Guidelines
CE Guidelines A-1MN792
CE Declaration of Conformity
Baldor indicates that the products are only components and not ready for immediate or instant use within the
meaning of “Safety law of appliance”, “EMC Law” or “Machine directive”.
The final mode of operation is defined only after installation into the user’s equipment. It is the responsibility of
the user to verify compliance.
The product conforms with the following standards:
DIN VDE 0160 / 05.88 Electronic equipment for use in electrical power installations
DIN VDE 0100 Erection of power installations with nominal voltages up to 1000V
DIN IEC 326 Teil 1 / 10.90 Design and use of printed boards
DIN VDE 0110Teil 1-2 / 01.89 Dimensioning of clearance and creepage
DIN VDE 0110Teil 20 / 08.90 distances
EN 60529 / 10.91 Degrees of protection provided by enclosures
EMC – Conformity and CE – Marking
The information contained herein is for your guidance only and does not guarantee that the installation will meet
the requirements of the council directive 89/336/EEC.
The purpose of the EEC directives is to state a minimum technical requirement common to all the member
states within the European Union. In turn, these minimum technical requirements are intended to enhance the
levels of safety both directly and indirectly.
Council directive 89/336/EEC relating to Electro Magnetic Compliance (EMC) indicates that it is the
responsibility of the system integrator to ensure that the entire system complies with all relative directives at the
time of installing into service.
Motors and controls are used as components of a system, per the EMC directive. Hence all components,
installation of the components, interconnection between components, and shielding and grounding of the
system as a whole determines EMC compliance.
The CE mark does not inform the purchaser which directive the product complies with. It rests upon the
manufacturer or his authorized representative to ensure the item in question complies fully with all the relative
directives in force at the time of installing into service, in the same way as the system integrator previously
mentioned. Remember, it is the instructions of installation and use, coupled with the product, that comply with
the directive.
Wiring of Shielded (Screened) Cables
Conductive
Clamp
Remove the outer insulation
to expose the overall screen.