Filter
Top Products
4-2 Receiving & Installation MN792
Cover Removal To connect power and signal wires, the cover must be removed. This procedure describes how to access all
terminal connections inside the control.
1. Loosen the two cover screws shown in Figure 4-8, then lift and remove the cover as shown.
Figure 4-1 Top Cover Removal
Cover
Screws
(2)
Lift and
remove cover
2. Locate the two 1/4 turn screws shown in Figure 4-2. Rotate each screw 1/4 turn CCW. This releases
the control from the base.
Figure 4-2 Signal Connections
1/4 Turn Screw 1/4 Turn Screw (1/4 turn to release,
press screw into hole to close).
Signal Connections
Power Connections (Control and base must
be opened to view, see Figure 4-9)
Communications Expansion
Board location
Feedback Expansion
Board location
Motor Ground
Power Ground
See Recommended Tightening Torques in Section 9.