Filter
Top Products
7-10 Keypad Operation MN792
Deactivate a Password
When password protection is activated, you can no longer edit the CHANGE PASSWORD
parameter until you deactivate the password protection (the value is displayed as “
****
”). First, enter the current
password (e.g. 0x0002) in the ENTER PASSWORD parameter.
Action Description Display Comments
Apply Power Keypad Display shows this opening
message.
FORWARD
REF: 0.00%
This message is different for each
control.
Press “PROG then
press “M” 2 times
Access the menus.
MENU LEVEL
DIAGNOSTICS
Press B
Scroll to “ENTER PASSWORD” menu.
MENU LEVEL
ENTER PASSWORD
Press “M” key Access the “ENTER PASSWORD”
choice.
PASSWORD
ENTER PASSWORD
Press “M” key Access the “ENTER PASSWORD”
choice.
ENTER PASSWORD
0X0000
Press Y or B key
Select the new password.
ENTER PASSWORD
0x0002
Enter password.
Press “E” key Exit one level
PASSWORD
ENTER PASSWORD
Press “E” several times to return to
the top level.
Now use the “Password Protection” procedure to set the Change Password value to “0X0000” to disable
password protection if desired.
Note: Because the ENTER PASSWORD parameter value is always reset to 0x0000 when powering–up the
drive, 0x0000 is the factory setting for the CHANGE PASSWORD parameter, i.e. by default, the two
parameter values are the same and so password protection is disabled.
1 PASSWORD
ENTER PASSWORD
CHANGE PASSWORD