Filter
Top Products
Polycom RMX 2000 Administrator’s Guide
12-37
The Spans table displays the following read-only fields:
— ID – The connector on the ISDN/PSTN card (PRI1 - PRI12).
— Slot – The MPM/MPM+ card that the ISDN/PSTN card is
connected to (1 or 2).
— Service – The Network Service to which the span is assigned, or
blank if the span is not assigned to a Network Service.
— Clock Source – Indicates whether the span acts as a clock source,
and if it does, whether it acts as a Primary or Backup clock
source. The first span to synchronize becomes the primary clock
source.
— State – The type of alarm: No alarm, yellow alarm or red alarm.
16 Assign spans to the Network Service by marking the appropriate
check boxes in the Attached field.
Each ISDN/PSTN card can support up to 7 E1 or 9 T1 PRI lines.
17 Click Save & Close.
The new ISDN/PSTN Network Service is created and added to the
ISDN/PSTN Network Services list.
Modifying an ISDN/PSTN Network Service
To Modify an ISDN/PSTN Network Service:
1 In the RMX Management pane, click the ISDN/PSTN Network
Services ( ) icon.
2 In the ISDN/PSTN Network Services list, double-click the ISDN or
right-click the ISDN entry and select Properties.
The ISDN Properties dialog boxes are displayed. They are similar to
the Fast Configuration Wizard’s dialog boxes. For more information see
"To Add an ISDN/PSTN Network Service:” on page 12-29.
The following ISDN Properties can be modified:
— PRI Settings
• Net Specific
• Dial-out Prefix