Filter
Top Products
Chapter 17-Hardware Monitoring
17-14
2 Right-click one of the hardware components indicating “Diagnostics”
in the status column and select Diagnostic from the drop-down
menu.
The Diagnostics pane is displayed at the bottom of the screen.
Repositioning the pane is enabled by clicking and dragging the pane
to the desired location on the screen, i.e. right side bar (displayed
below).
3 Select the Test(s) to perform in the section labeled Diagnostics Test
Selection by marking the check boxes in the TestActive column.
Each column in the Diagnostics Test Selection is interchangeable.
Click, hold and slide a column left or right to the desired position.
The type of tests that can be selected in the Test Selection depend on
the hardware component. Each component enables different tests.
Diagnostics Test Selection
Diagnostics Test Monitoring