Filter
Top Products
17
FX3G Series Programmable Controllers
User's Manual - Hardware Edition
Standards
Requirement for Compliance with LVD directive
The following products have shown compliance through direct testing (of the identified standards below) and
design analysis (through the creation of a technical construction file) to the European Directive for Low
Voltage (2006/95/EC) when used as directed by the appropriate documentation.
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with IEC1010-1
from April 1st, 2002 to April 30th, 2006 are compliant with EN61131-2:1994+A11:1996+A12:2000
after May 1st, 2006 are compliant with EN61131-2:2007
Type : Programmable Controller (Open Type Equipment)
Models : MELSEC FX
3G series manufactured
from November 1st, 2008
FX3G-MT/ES
Where indicates:14,24,40,60
from December 1st, 2008
FX3G-MR/ES
Where indicates:14,24,40,60
from March 1st, 2009
FX3G- MT/ESS
Where indicates:14,24,40,60
from December 1st, 2009
FX
3G- MR/DS
Where indicates:14,24,40,60
Standard Remark
EN61131-2:2007 Programmable controllers
- Equipment requirements and tests
The equipment has been assessed as a component for fitting in a suitable
enclosure which meets the requirements of EN61131-2:2007
Models : MELSEC FX2N series manufactured
from July 1st, 1997
FX2N-ER-ES/UL FX2N- ET-ESS/UL
Where indicates:32,48
FX2N-16EYR-ES/UL
from April 1st, 1998 FX2N-48ER-DS
from August 1st, 1998 FX2N-48ER-UA1/UL
from August 1st, 2005 FX2N-8ER-ES/UL FX2N-8EYR-ES/UL
from September 1st, 2010 FX2N-8EYR-S-ES/UL
Standard Remark
IEC1010-1:1990 Safety requirements for electrical
/A1:1992 equipment for measurement, control,
and laboratory use
- General requirements
The equipment has been assessed as a component for fitting in a
suitable enclosure which meets the requirements of IEC 1010-
1:1990+A1:1992
EN61131-2:1994 Programmable controllers
/A11:1996 - Equipment requirements and tests
/A12:2000
The equipment has been assessed as a component for fitting in a
suitable enclosure which meets the requirements of EN61131-
2:1994+A11:1996+A12:2000
EN61131-2:2007 Programmable controllers
- Equipment requirements and tests
The equipment has been assessed as a component for fitting in a
suitable enclosure which meets the requirements of EN61131-2:2007