Filter
Top Products
5 Version Information and Peripheral Equipment Connectability
5.2 Programming Tool Applicability
61
FX3G Series Programmable Controllers
User's Manual - Hardware Edition
1
Introduction
2
Features and
Part Names
3
Product
Introduction
4
Specifications
5
Version and
Peripheral
Devices
6
System
Configuration
7
Input/Output
Nos., Unit Nos.
8
Installation
9
Preparation and
Power Supply
Wiring
10
Input Wiring
• Japanese version
*1. Write during RUN is not possible with a SFC program.
*2. Write during RUN is not possible with a list program or a SFC program.
Cautions on write during RUN
*1. Circuit blocks cannot be edited to insert a label as shown below when written during RUN.
Programming tool Version Remarks
GX Works2
*1
(SW DNC-GXW2-J)
Ver. 1.07H or later
Writing in the instruction and device ranges during RUN is supported in FX3G PLCs
earlier than Ver. 1.40.
Ver. 1.56J or later
Writing in the instruction and device ranges during RUN is supported in FX3G PLCs
Ver. 1.40.
GX Developer
*2
(SW D5C-GPPW-J)
Ver. 2.00A or later
Writing in the instruction and device ranges during RUN is supported in FX
2N PLCs
Ver. 1.00.
Ver. 5.00A or later
Writing in the instruction and device ranges during RUN is supported in FX1N PLCs
Ver. 1.00.
Ver. 8.72A or later
Writing in the instruction and device ranges during RUN is supported in FX3G PLCs
earlier than Ver. 1.10.
Ver. 8.76E or later
Writing in the instruction and device ranges during RUN is supported in FX3G PLCs
Ver. 1.10.
FX-PCS/WIN
*2
Ver. 4.00 or later
Writing in the instruction and device ranges during RUN is supported in FX1N PLCs
Ver. 1.00.
Item Caution
Program memories which can be
written in RUN mode
Built-in EEPROM and optional memory cassette (whose write protect switch is set to OFF)
Number of
program steps
which can be
written for
circuit change
in RUN mode
•GX Works2
Ver. 1.08J or later
•GX Developer
Ver. 8.72A or later
256 steps or less after edition (addition/deletion) (including NOP
immediately after circuit blocks except final circuit)
•GX Developer
Ver. 8.70Y or
former
• FX-PCS/WIN(-E)
127 steps or less after edition (addition/deletion) (including NOP
immediately after circuit blocks except final circuit)
Circuit blocks which cannot be written
in RUN mode
Circuit blocks
*1
in which labels P and I are added, deleted or changed in edited circuits
Circuit blocks in which 1-ms timers (T246 to T249 and T256 to T319) are added in edited circuits
Circuit blocks in which the following instructions are included in edited circuits
• Instruction to output high-speed counters C235 to C255 (OUT instruction)
• TBL (FNC152) instruction
I001
FNC 04
EI
FNC 06
FEND
Pointer for
interrupt
Label I is inserted by editing the circuit block
FNC 03
IRET
END
Step
0
Added, deleted, or changed
Added, deleted, or changed