Mitsubishi Electronics FX3G Universal Remote User Manual


 
4 Specifications, External Dimensions and Terminal Layout (Main Units)
4.7 Terminal Layout
53
FX3G Series Programmable Controllers
User's Manual - Hardware Edition
1
Introduction
2
Features and
Part Names
3
Product
Introduction
4
Specifications
5
Version and
Peripheral
Devices
6
System
Configuration
7
Input/Output
Nos., Unit Nos.
8
Installation
9
Preparation and
Power Supply
Wiring
10
Input Wiring
4.7 Terminal Layout
The terminal layout in the main unit is shown below.
4.7.1 Interpretation of terminal block layout
Indication of Power supply terminals
The AC power supply type has [L] and [N] terminals.
The DC power supply type has [ ] and [ ] terminals.
For external wiring, make sure to read the power supply wiring described later.
Refer to Chapter 9.
Indication of 24V DC service power supply
The AC power supply type has [0V] and [24V] terminals, whereas the DC power supply type shows [•]
since the DC power supply type does not have the service power supply.
Do not connect with [•] terminals.
For external wiring, make sure to read the power supply wiring described later.
Refer to Chapter 9.
Indication of Input terminal
Both AC and DC power supply type have the same input terminals, however, the external input wiring
differs from each other.
For external wiring, make sure to read the input wiring described later.
Refer to Chapter 10.
Indication of output terminals connected to common terminal
One common terminal covers 1, 2, 3 or 4 output points.
The output numbers (Y) connected to a common terminal are enclosed with heavy partition lines.
For transistor output (source) type, [COM ] is [+V ].
Partition
Common terminal
(4 points/common
terminal)
X3S/S X1
X2NL X4
X5
X6
X7
X10
X11
X12
X13
X14
X15
X16
X17
Y2Y0
COM1COM2COM0
0V
24V
Y3
COM3
Y6
Y7
COM4
Y12
Y13
COM5
Y5 Y11
X20
X21
X22
X23
X24
X25
X26
X27
Y14
Y15
Y16
Y17
FX
3G
-40MT/ES
Y1 Y4 Y10
X0
Output
terminal
Output terminals
connected to COM5
Input terminalPower supply terminals
24V DC service
power supply
[ ·
] Vacant terminal (Do not use.)