Filter
Top Products
20 Terminal Block
20.9 FX-16EYS-TB
372
FX3G Series Programmable Controllers
User's Manual - Hardware Edition
20.9 FX-16EYS-TB
The FX-16EYS-TB is used by connecting it to the FX2N series output extension block (transistor).
The applications shown below are not supported.
20.9.1 Specifications
*1. In systems where frequent large-load ON/OFF switching occurs due to rush currents, the root mean
square current should be 0.2 A or less.
*2. This response time does not include the response delay at the PLC.
Output Connector
Connectable models FX2N-16EYT-C (sink output)
Unsupported Applications
Pulse outputs
Pulse Y output (PLSY) instruction, acceleration/deceleration setup (PLSR) instruction, pulse width modulation
(PWM) instruction, DOG search zero return (DSZR) instruction, batch data positioning mode (TBL) instruction,
absolute current value read (ABS) instruction, zero return (ZRN) instruction, variable speed pulse output (PLSV)
instruction, drive to increment (DRVI) instruction, drive to absolute (DRVA) instruction
Time division inputs Input matrix (MTR) instruction, digital switch (DSW) instruction
Time division output Seven segment with latch (SEGL) instruction
Item Triac output
Input/output
circuitry
Load voltage 85 to 242V AC
Max.
load
Resistance
load
0.3A/point
*1
The total load current of resistance loads per common terminal should be the following
value.
• 4 output points/common terminal: 0.8A or less
Inductive
load
15VA/100V AC
36VA/200V AC
Min. load
0.4VA/100V AC
1.6 VA/200V AC
Open-circuit
leakage current
1mA/100V AC
2mA/200V AC
Response time
*2
2ms or less
Circuit isolation Photocoupler isolation
Operation
indicators
Activation of the photo-thyristor will light the LED indicator lamp on panel.
Power
consumption
2.7W (112mA 24V DC)
0 to 7
COMn
Photo-
thyristor
External wiring
CN1
connector
side
3.3k
LED
2.2
0.015
F
7mA Fuse
U
24+
0.4A
0.7
sec
4A
10
sec
0.02
sec
0.02 + 0.7 + 10
4
2
0.02 + 0.4
2
0.7
= 0.2A
<Example>