Filter
Top Products
18
FX3G Series Programmable Controllers
User's Manual - Hardware Edition
Standards
Caution for compliance with EC Directive
1. Installation in Enclosure
Programmable logic controllers are open-type devices that must be installed and used within conductive
control boxes. Please use the FX
3G Series programmable logic controllers while installed in conductive
shielded control boxes. Please secure the control box lid to the control box (for conduction). Installation within
a control box greatly affects the safety of the system and aids in shielding noise from the programmable logic
controller.
2. Caution for Analog Products in use
The analog products have been found to be compliant to the European standards in the aforesaid manual
and directive. However, for the very best performance from what are in fact delicate measuring and controlled
output devices, Mitsubishi Electric would like to make the following points;
As analog devices are sensitive by nature, their use should be considered carefully. For users of proprietary
cables (integral with sensors or actuators), these users should follow those manufacturers' installation
requirements.
Mitsubishi Electric recommends that shielded cables be used. If NO other EMC protection is provided, users
may experience temporary loss or accuracy between +10% / -10% in very heavy industrial areas.
However, Mitsubishi Electric suggests that if adequate EMC precautions are followed for the users complete
control system.
- Sensitive analog cables should not be laid in the same trunking or cable conduit as high voltage cabling.
Where possible, users should run analog cables separately.
- Good cable shielding should be used. When terminating the shield at Earth - ensure that no earth loops
are accidentally created.
- When reading analog values, EMC accuracy can be improved by averaging the readings. This can be
achieved either through functions on the analog special adapters/boards/blocks or through a user's
program in the FX
3G Series PLC main unit.