Filter
Top Products
Teledyne API - Model 200EH/EM Operation Manual Operating Instructions
93
NOTE
It is a good idea to check these settings the first time you power up your analyzer after
it has been physically connected to the LAN/Internet to make sure that the DHCP has
successfully downloaded the appropriate information from you network server(s).
If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g. “0.0.0.0”),
the DCHP was not successful.
You may have to manually configure the analyzer’s Ethernet properties.
See your network administrator.
To view the above properties, press:
SAMPLE ENTER SETUP PASS : 818
8 1 8
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE
SAMPLE A1:NXCNC1=100PPM
NOX=XXX.X
SETUP X.X COMMUNICATIONS MENU
ID INET COM1
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X DHCP: ON
SET> EDIT
SETUP X.X INST IP: 0.0.0.0
<SET SET>
SETUP X.X GATEWAY IP: 0.0.0.0
<SET SET>
SETUP X.X SUBNET MASK: 0.0.0.0
<SET SET>
SETUP X.X TCP PORT: 3000
<SET SET> EDIT
SETUP X.X HOSTNAME: M200EH
<SET EDIT
EDIT Key
Disabled
Do not alter unless
directed to by Teledyne
Instruments Customer
Service personnel
From this point on,
EXIT returns to
COMMUNICATIONS
MENU
04521C (DCN5731)