Filter
Top Products
Operating Instructions Teledyne API - Model 200EH/EM Operation Manual
62
6.5. SETUP CFG: VIEWING THE ANALYZER’S
CONFIGURATION INFORMATION
Pressing the CFG key displays the instrument configuration information. This display lists the analyzer model,
serial number, firmware revision, software library revision, CPU type and other information. Use this information
to identify the software and hardware when contacting customer service. Special instrument or software
features or installed options may also be listed here.
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
SAMPLE
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE M100E NOX
A
NALYZER
NEXT PREV EXIT
Press EXIT at
any time to
return to
SETUP menu
Press EXIT at
any time to
return to the
SAMPLE dis
p
la
y
Press NEXT of PREV to move back
and forth through the following list
of Configuration information:
MODEL NAME
SERIAL NUMBER
SOFTWARE REVISION
LIBRARY REVISION
iCHIP SOFTWARE REVISION
1
HESSEN PROTOCOL REVISION
1
ACTIVE SPECIAL SOFTWARE
OPTIONS
1
CPU TYPE
DATE FACTORY CONFIGURATION
SAVED
1
Only appears if relevant option of Feature is active.
6.6. SETUP ACAL: AUTOMATIC CALIBRATION
Instruments with one of the internal valve options installed can be set to automatically run calibration procedures
and calibration checks. These automatic procedures are programmed using the submenus and functions found
under the
ACAL menu.
A menu tree showing the
ACAL menu’s entire structure can be found in Appendix A-1 of this manual.
Instructions for using the
ACAL feature are located in the Section 7.7 of this manual along with all other
information related to calibrating the M200EH/EM analyzer.
04521C (DCN5731)