Filter
Top Products
Operating Instructions Teledyne API - Model 200EH/EM Operation Manual
104
To access and navigate the VARS menu, use the following key sequence:
SETUP X.X 7) CLOCK_ADJ=0 Sec/Day
+ 0 0 ENTR EXIT
SETUP X.X 6) CONC_PRECUISION : 3
AUTO 0 1 2 3 4 ENTR EXIT
SETUP X.X 6) CONC_PRECUISION : 1
PREV NEXT JUMP EDIT PRNT EXIT
Toggle these keys to change setting
SETUP X.X 2 ) STABIL GAS =NOX
NO NO
2
NOX O2 ENTR EXIT
SETUP X.X 2 ) STABIL_GAS=NOX
PREV NEXT JUMP EDIT PRNT EXIT
Choose Gas
SETUP X.X 1 ) MEASURE_MODE=NO
X
-NO
NEXT JUMP EDIT PRNT EXIT
SAMPLE RANGE = 500.0 PPB NOX=X.X
< TST TST > CAL SETUP
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X 0 ) DAS_HOLD_OFF=15.0 Minutes
NEXT JUMP EDIT PRNT EXIT
SETUP X.X 3 ) TPC_ENABLE=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X ENTER VARS PASS: 818
8 1 8 ENTR EXIT
SETUP X.X 0) DAS_HOLD_OFF=15.0 Minutes
1 5 .0 ENTR EXIT
SETUP X.X 7) CLOCK_ADJ=0 Sec/Day
PREV NEXT JUMP EDIT PRNT EXIT
EXIT ignores the new setting.
ENTR accepts the new setting.
SETUP X.X 3 ) TPC_ENABLE=ON
ON ENTR EXIT
SETUP X.X 4 ) DYN_ZERO=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 4 ) DYN_ZERO=ON
ON ENTR EXIT
Toggle this keys to change setting
Toggle this keys to change setting
SETUP X.X 5) DYN_SPAN=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 5 ) DYN_SPAN=ON
ON ENTR EXIT
Toggle this keys to change setting
Toggle this keys to change setting
Toggle this keys to change setting
See Section 6.12.1. for
information on setting the
MEASRUE MODE
04521C (DCN5731)