Filter
Top Products
Teledyne API - Model 200EH/EM Operation Manual Operating Instructions
77
6.7.2.10. Disabling/Enabling Data Channels
Data channels can be temporarily disabled, which can reduce the read/write wear on the disk-on-chip. The
HIRES channel of the M200EH/EM, for example, is disabled by default.
To disable a data channel, follow the instruction shown in section 6.7.2.2 then press:
Edit Data Channel Menu
SETUP X.X
0)
CONC: ATIMER, 8, 800
PREV NEXT INS DEL EDIT PRNT EXIT
Exits to the main
Data Acquisition
menu
SETUP X.X NAME:CONC
<SET SET> EDIT PRINT EXIT
SETUP X.X CHANNEL ENABLE:ON
<SET SET>
EDIT
PRINT EXIT
ENT
R
accepts the new
setting and returns to the
previous menu.
EXIT
ignores the new setting
and returns to the previous
menu.
SETUP X.X CHANNEL ENABLE:ON
OFF ENTR EXIT
Toggle key to turn
channel ON or OFF
Press
SET>
key until…
From the
DATA ACQUISITION
menu
(see Section 6.7.2.2)
6.7.2.11. HOLDOFF Feature
The iDAS HOLDOFF feature allows to prevent data collection during calibrations and during the
DAS_HOLDOFF period enabled and specified in the VARS (Section 6.12). To enable or disable the HOLDOFF
for any one iDAS channel, follow the instruction shown in section 6.7.2.2 then press:
Edit Data Channel Menu
SETUP X.X 0) CONC: ATIMER, 2, 900
PREV NEXT INS DEL EDIT PRNT EXIT
Exits to the main
Data Acquisition
menu
SETUP X.X NAME:CONC
<SET
SET>
EDIT
PRINT EXIT
SETUP X.X CAL HOLD OFF:ON
SET> EDIT PRINT EXIT
ENTR accepts the new
setting and returns to the
previous menu.
EXITignores the new setting
and returns to the previous
menu.
SETUP X.X CAL HOLD OFF:ON
ON ENTR EXIT
Toggle key to turn
HOLDOFF ON or OFF
Press
SET>
key until…
From the
DATA ACQUISITION
menu
(see Section 6.7.2.2)
04521C (DCN5731)