Filter
Top Products
Teledyne API - Model 200EH/EM Operation Manual Operating Instructions
61
6.4. SETUP MODE
The SETUP mode contains a variety of choices that are used to configure the analyzer’s hardware and software
features, perform diagnostic procedures, gather information on the instruments performance and configure or
access data from the internal data acquisition system (iDAS). The areas access under the Setup mode are:
Table 6-4: Primary Setup Mode Features and Functions
MODE OR FEATURE
KEYPAD
LABEL
DESCRIPTION
MANUAL
SECTION
Analyzer Configuration
CFG
Lists key hardware and software configuration information 6.5
Auto Cal Feature
ACAL
Used to set up an operate the AutoCal feature. Only appears if
the analyzer has one of the internal valve options installed
7.7
Internal Data Acquisition
(iDAS)
DAS
Used to set up the iDAS system and view recorded data 6.7
Analog Output Reporting
Range Configuration
RNGE
Used to set the units of measure for the display and set the
dilution ratio on instruments with that option active.
6.8
Calibration Password Security
PASS
Turns the password feature ON/OFF 6.9
Internal Clock Configuration
CLK
Used to Set or adjust the instrument’s internal clock 6.10
Advanced SETUP features MORE
This button accesses the instruments secondary setup menu
See
Table 6-5
Table 6-5: Secondary Setup Mode Features and Functions
MODE OR FEATURE
KEYPAD
LABEL
DESCRIPTION
MANUAL
SECTION
External Communication
Channel Configuration
COMM
Used to set up and operate the analyzer’s various external I/O
channels including RS-232; RS 485, modem communication
and/or Ethernet access.
6.11 &
6.15
System Status Variables
VARS
Used to view various variables related to the instruments current
operational status
6.12
System Diagnostic Features
and
Analog Output Configuration
DIAG
Used to access a variety of functions that are used to configure,
test or diagnose problems with a variety of the analyzer’s basic
systems.
Most notably, the menus used to configure the output signals
generated by the instruments Analog outputs are located here.
6.13
Alarm Limit Configuration
1
ALRM
Used to turn the instrument’s two alarms on and off as well as
set the trigger limits for each.
6.14
1
Only present if the optional alarm relay outputs (Option 67) are installed.
NOTE
Any changes made to a variable during one of the following procedures is not
acknowledged by the instrument until the ENTR Key is pressed
If the EXIT key is pressed before the ENTR key, the analyzer will beep, alerting the user
that the newly entered value has not been accepted.
04521C (DCN5731)