Filter
Top Products
APPENDIX A-1: M200EH/EM Software Menu Trees, Revision F.0 Model 200EH/EM (Ref: 05147F)
A-4
SETUP
PASS
DAS
RNGE
CLK
MOREACAL
1
CFG
SAMPLE
1
ACAL menu only appear if analyzer is equipped with
Zero/Span or IZS valve options.
2
Editing an existing iDAS channel will erase any
data stored on the channel
options.
3
Changing the event for an existing iDAS
channel DOES NOT erase the data stored on
the channel.
EDITVIEW
PREV NEXT
CONC
CALDAT
CALCHE
DIAG
HIRES
VIEW
Selects the data point to be viewed
Cycles through
parameters
assigned to this
iDAS channel
<PRM
PRM>NX10NEXTPREVPV10
EDIT
2
PRNTDELINSNEXTPREV
ENTER PASSWORD: 818
CONC
CALDAT
CALCHE
DIAG
HIRES
NO
NX10NEXTSET><SET
YES
NAME
EVENT
PARAMETERS
NUMBER OF RECORDS
REPORT PERIOD
RS-232 REPORT
CAL MODE
CHANNEL ENABLE
ON
OFF
NO
YES
2
Sets the maximum number of
records recorded by this
channel
Sets the time lapse between
each report
Create/edit the name of the channel
PREV NEXT
Cycles through
list of available
trigger events
3
NOYES
2
EDIT
2
PRNTDELINSNEXTPREV
NO
PRNTEDITSET><SET
YES
Cycles through list of
currently active
parameters for this
channel
MAXMINAVGINST
PRECISIONSAMPLE MODEPARAMETER
Cycles through list of available &
currently active parameters for
this channel
NEXTPREV
Figure A-3: Primary Setup Menu
iDAS Submenu
04521C (DCN5731)