Filter
Top Products
Teledyne API - Model 200EH/EM Operation Manual Optional Hardware and Software
37
5. OPTIONAL HARDWARE AND SOFTWARE
This section includes a descriptions of the hardware and software options available for the Model 200EH/EM
Nitrogen Oxides Analyzer. For assistance with ordering these options please contact the sales department of
Teledyne - Advanced Pollution Instruments at:
TOLL-FREE: 800-324-5190
TEL: +1 858-657-9800
FAX: +1 858-657-9816
E-MAIL: apisales@teledyne.com
WEB SITE: http://www.teledyne-api.com/
5.1. EXTERNAL PUMPS (OPT 10)
The M200EH/EM comes equipped with an external pump specified upon ordering. Whereas the analyzer can
be re-configured for other voltages, operation at other than the original voltage/frequency may require a different
external pump. A variety of external pumps are available for the M200EH/EM series analyzers. The range of
available pump options meets all typical AC power supply standards while exhibiting the same pneumatic
performance.
TELEDYNE
INSTRUMENTS PART NO.
DESCRIPTION
009810300 External pump for 115 VAC / 60 Hz power supply
009810400 External pump for 230 VAC / 50 Hz power supply
009810500 External pump for 110 VAC / 50 Hz power supply
009810600 External pump for 100 VAC / 50 Hz power supply
009810700 External pump for 220-240 VAC / 50-60 Hz power supply
5.2. RACK MOUNT KITS (OPTS 20-23)
There are several options for mounting the analyzer in standard 19” racks. The slides are three-part extensions,
one mounts to the rack, one mounts to the analyzer chassis and the middle part remains on the rack slide when
the analyzer is taken out. The analyzer locks into place when fully extended and cannot be pulled out without
pushing two buttons, one on each side.
The rack mount brackets for the analyzer requires that you have a support structure in your rack to support the
weight of the analyzer. The brackets cannot carry the full weight of an analyzer and are meant only to fix the
analyzer to the front of a rack and to prevent it from sliding out of the rack through user intervention or vibration.
OPTION NUMBER DESCRIPTION
OPT 20A Rack mount brackets with 26 in. chassis slides.
OPT 20B Rack mount brackets with 24 in. chassis slides.
OPT 21 Rack mount brackets only
OPT 23 Rack mount for external pump (no slides).
04521C (DCN5731)